Ubiquiti airFiber 11FX, Руководство пользователя

Страница: 29 / 58

23
Chapter 5: Wireless Tab airFiber AF-11FX User Guide
Ubiquiti Networks, Inc.
Key Select the format of the MAC address.
• HEX Enter 16 bytes (eight, 16-bit hexadecimal values).
You can omit zeroes and use colons, similar to the IPv6
format. The default is:
0000:0000:0000:0000:0000:0000:0000:0000
Note: The airFiber Configuration Interface
supports IPv6 formats excluding dotted quad and
“::” (double‑colon) notation.
• ASCII Enter a combination of alphanumeric characters.
Using 128‑bit SHA1 (Secure Hash Algorithm 1), the
airFiber X radio hashes the ASCII key to create a 128-bit
key for AES.
Advanced Wireless Settings
Enhanced MIMO Select this option to enable the
Enhanced MIMO feature. Enhanced MIMO increases
sensitivity which may result in greater TX throughput
in low‑noise environments. If enabling this feature does
not result in improved throughput, the noise level is too
high and you should disable this feature. This feature is
disabled by default.
Automatic Power Backoff This feature allows the radio
to automatically adjust the maximum TX power per
modulation so that the radio never transmits at a higher
power than each modulation rate can decode. The default
values in the
Max 10x/8x/6x/4x Conducted Power fields
are values determined to work at all temperatures and all
frequencies supported by the radio.
It may, however, be possible to increase the maximum
TX power for one or more modulations based on your
radio’s operating environment. For example, if a radio
is running at 6x and trying to switch into 8x operation,
you can increase the
Max 8x Conducted Power value 1 dB
at a time to see if the radio can maintain 8x operation
(
Automatic Power Backoff must be enabled to allow the
Max Conducted Power fields to be edited). The same can
be done with 6x and 4x up to the maximum conducted
power of the radio.
Max 10x/8x/6x/4x Conducted Power The maximum
conducted power for the 10x/8x/6x/4x modulation rates.
Each field is editable only if
Automatic Power Backoff is
enabled.
Restore Default Backoffs
Click
Restore
to restore the
default Max Conducted Power values.