UbiBot LD1, Руководство пользователя

Страница: 8 / 11

ERROR CODES
FAQ
DEVICE SPECIFICATION
1. Device network configuration failure reasons
① Please check whether the WiFi account password is correct;
② Please check whether the router is working properly and the network connection is normal;
③ Please make sure the device has entered the WiFi configuration mode;
④ Please check whether the WiFi band is 2.4GHz and the channel is between 1~13;
⑤ Please check the WiFi channel width is set to 20MHz or auto mode;
⑥ WiFi security type: LD1 supports OPEN, WEP and WPA/WPA2-personal;
⑦ Poor signal strength, please check the WiFi or cell phone data traffic signal strength.
7
WiFi 2.4GHz, channel 1-13 Flame resistant ABS + PC
115mm x 90mm x 55mm
Device working environment: -20 to 60℃, 10-90%RH
Built-in memory: 300,000 sending data
Support Ethernet RJ-45 port（10/100 Mbps）*
Type-C, DC 12V/1A power supply
SIM
Supports Micro SIM card (15 x 12 x 0.8mm)*
02 WiFi Connection Failed: Please refer to the Troubleshooting section 3.
03 Failed to Connect to Server: Please refer to the Common Questions at https://www.ubibot.com/category/faqs/
04 Device Activation Failed: Please refer to the Troubleshooting section 1.
05 Data Save Failure: This can happen when the power is disrupted while data is being saved.
07 Data Sync Failed: Please refer to the Troubleshooting section 3.
08 No SIM Card Found: Please check the SIM card is correctly inserted.
09 Mobile Data Network Failure: Please check your SIM card is set up correctly and has been activated.
10 Network cable* not detected: Please check if your network cable* is plugged into the device.
11 Network cable* connection failure: Please check if your network cable* is working properly.
12 IP address conflict: Please check whether your IP address is in conflict with other devices.
Auto-sensing Half/Full Duplex Switched Port*
Non-corrosive conductive liquid