Ubermann UHD04CHI, Руководство пользователя, Страница: 27 / 36

7 — English
OPERATION
WARNING:
Do not allow familiarity with this product to make you careless.
Remember that a careless fraction of a second is sufficient to
inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to comply
with ANSI Z87.1 or equivalent standard, along with hearing
protection. Failure to do so could result in objects being thrown
into your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not recommended
by the manufacturer of this product. The use of attachments or
accessories not recommended can result in serious personal
injury.
Applications
You may use this product for the purposes listed below:
•
Hammer drilling in concrete, brick, or other masonry
•
Drilling in all types of wood products (lumber, plywood,
paneling, composition board, and hard board), ceramics,
plastics, fiberglass, laminates, and metals; driving screws
into wood and drywall with screwdriver bits
Installing Belt Clip
See Figure 3, page 12.
The belt hook may be installed on either side of the housing.
•
Align hole in belt hook with hole in tool’s base.
•
Install screw to secure belt hook in place.
Variable Speed Switch Trigger
See Figure 4, page 12.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the drill ON, depress the switch trigger. To turn it OFF,
release the switch trigger and allow the chuck to come to a
complete stop.
NOTE: A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
NOTE: Running at low speeds under constant usage may cause
the drill to become overheated. If this occurs, cool the drill by
running it without a load and at full speed.
Direction of Rotation Selector
(Forward/Reverse/Center Lock)
See Figures 4 - 5, page 12.
Set the direction of rotation selector in the OFF (center lock)
position to lock the switch trigger and help prevent accidental
starting when not in use.
Position the direction of rotation selector to the left of the
switch trigger for forward drilling. Position the selector to the
right of the switch trigger to reverse the direction.
NOTE: The drill will not run unless the direction of rotation
selector is pushed fully to the left or right.
To prevent gear damage, always allow the chuck to come to a
complete stop before changing the direction of rotation.
WARNING:
Battery tools are always in operating condition. Lock the switch
when not in use or carrying at your side, when installing or
removing the battery pack, and when installing or removing bits.
Installing/Removing Battery Pack
See Figure 6, page 13.
•
Lock the switch trigger.
•
Insert the battery pack into the product as shown.
•
Make sure the latches on each side of the battery pack snap
in place and that battery pack is secured in the product before
beginning operation.
•
Depress the latches to remove the battery pack.