2
IMPORTANT SAFETY INSTRUCTIONS
WARNING!
When using electrical appliances, basic precautions should always be
followed to reduce the risk of fire,electric shock,and injury to persons including the following.
INSTRUCTIONS FOR USE AND CARE
1. Read all instructions carefully before using this heater.
2. This heater becomes hot when in use. To avoid burns, do not touch hot surfaces. Use carry handle
when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and away from the sides and rear.
3. Extreme caution is necessary when a heater is used by or near children or individuals with disabilities
and whenever the heater is left operating and unattended.
4. Always unplug the heater when not in use.
5. Do not operate a heater with a damaged cord or plug or after the heater malfunctions, has been dropped
or damaged in any manner. Discard heater or return the heater to an authorized service facility for
examination, electrical or mechanical adjustment, or repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry rooms or in wet or moist locations. Never place
the heater where it may fall in to a bathtub or other water containers.
8. Do not run the electric cord under carpeting. Do not cover the cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and
where it will not be tipped over.
9.
!CAUTION:
This appliance has a polarized plug(one blade is wider than the other), to reduce the risk of
shock .This plug is intended to fit only one way in a polarized outlet. If the plug does not fit fully in the
outlet, reverse the plug. If it still not fit, contact a qualified electrician. DO NOT attempt to defeat this
safety feature. To do so could result in an electric shock hazard.
10. To disconnect heater, first turn controls to off, then remove plug from outlet. Never pull by the cord.
11. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
12. To reduce the risk of fire, do not block air intakes or the exhaust in any manner. Do not use on soft
surfaces, like a bed, where openings may become blocked.
13. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or
flammable liquids are used or stored.
14. Use this heater only as instructed in this manual. Any other use not recommended by the manufacturer
may cause fire, electric shock, or injury to persons.
15.
!CAUTION:
Always plug heater directly into a wall outlet/receptacle. Never use with an extension cord
or relocatable power tap(outlet/power strip).
16. This heater draws 12.5 amps during operation. To prevent overloading a circuit, do not plug the heater
into a circuit that already has other appliances working.
17.
!CAUTION:
It is normal for the plug to feel warm to the touch, however, a loose fit between the AC
outlet (receptacle) and the plug may cause overheating and distortion of the plug. Contact a qualified
electrician to replace loose or worn outlet.
18. The output of this heater may vary and its temperature may become intense enough to burn exposed
skin. Use of this heater is not recommended for persons with reduced sensitivity to heat or an inability
to react to avoid burns.
SAVE THESE IMPORTANT INSTRUCTIONS FOR EASY REFERENCE
°C
Temperature
is displayed
in degrees
Celsius
UNPACKING AND SET-UP INSTRUCTIONS
Unpack the heater, and remove the base from the package.
1. Make sure the heater is unplugged and is turned off.
2. Turn the heater upside down.
3. Align the two hole assemblies of the two half bases, and position them as shown in
the figure above.
4. Insert the butterfly nuts, and tighten them securely.
5. Turn the heater upright.
OPERATION INSTRUCTIONS
3
