15
WARNING
When lighting, keep your face and hands as far
away from the grill as possible.
CAUTION
When using a match to light the grill make sure to
use the attached lighting rod.
CAUTION
Remove the warming rack when using a match
to light the grill.
necessary to turn the heat to a lower setting after the initial browning. This method cooks the food
thoroughly without burning the outside.
Food cooked for a long time or basted with a sugar-based marinade may need a lower heat setting near
the end of its cooking time.
To begin:
1. Make sure the grill has been leak tested and is properly placed. (See page 16.)
2. Remove any remaining packing materials.
3. Light the grill burners using the Lighting Instructions below.
4. Turn the control knob(s) to the
“
IGNITE / HIGH
”
setting, and preheat the grill for 15 minutes. The grill
lid should be closed during the pre-heat period.
5. Place the food on the grill and cook to the desired degree of preparation. If necessary, adjust the heat
setting. The control knob may be positioned at any setting between
“
HIGH
”
and
“
LOW
”
.
LIGHTING INSTRUCTIONS
Before Lighting
Inspect the gas supply hose prior to turning on the gas. If there is evidence of cuts, wear, or abrasion, it
must be replaced prior to use.
Screw the regulator (type QCC1) onto the cylinder, and leak check the hose and regulator connections
before operating the grill (see the
“
Leak Testing
”
instructions on page 16).
Only the pressure regulator and hose assembly supplied with the unit should be used. Never substitute
regulators. If a replacement is necessary, contact customer service for proper replacement.
WARNING
Do not use the grill if the odour of gas is present. Contact customer service at 1-866-206-0888.
TO LIGHT THE MAIN BURNERS
1. Open lid during lighting.
2. Make sure all the knobs are in the
“
OFF
”
position, and then turn the Liquid Propane Cylinder valve
“
ON
”
by slowly turning counterclockwise.
3. Push and turn Main Burner control knob to IGNITE/HIGH, at the same time, press and hold
electronic ignition button to light the burner.
4. Once the burner is lit, release the electronic ignition button and knob.
5. If ignition does not occur in 5 seconds, turn the knob to OFF, wait 5 minutes and repeat the lighting
procedure or light by match.
TO MATCH LIGHT THE GRILL
If a burner will not light after several attempts using the control knobs, the burners may be lit with a match.
文件使用
"pdfFactory Pro"
试用版本创建
