UBC1310BA10
Advanced Wireless Voice Gateway
Quick Installation Guide
Subscriber User
Grounding the Device:
Install the cable modem to include
grounding the coaxial cable to the earth as close as practical to
the building entrance per ANSI/NFPA 70 and the National
Electrical Code (NEC, in particular, Section 820.93, Grounding of
the Outer Conductive Shield of a Coaxial Cable).
This unit requires a 100-240V, 50/60Hz power adapter. Power
cable must be keyed for proper polarization, and must be fully
inserted to contact the back of the power connector port to
ensure snug connection. Do NOT use any other power adapter.
Disconnecting the Device:
If the cable modem becomes
damaged or encounters some other abnormality, disconnect the
power plug from the AC wall outlet immediately.
Temperature and Altitude:
Install the device in a location not to
exceed the maximum temperature of 40˚ Celsius). Regular
operating altitude is 2000 m, and maximum operating altitude is
5000 m.
•
SAFETY NOTICES
•
PREPARING FOR INSTALLATION
✓
Verify package contents, RF cable connectors, and power
outlet.
✓
Locate the RF (coaxial) cable connector on the wall.
✓
Verify the power outlet is working and is wired correctly.
Place your cable modem within a proper distance from
the outlet.
•
INSTALLING THE MODEM
1. Connect a coaxial cable (not supplied) to the CABLE connector
on the rear panel of the device and connect the other end to
the cable wall outlet. Do not bend or over tighten the cables, as
this may strain the connector and cause damage. To connect a
modem and a television to the same wall outlet, you must use a
cable line splitter (not included).
2. Connect the Ethernet cable (supplied) to the Ethernet port on
the back panel of the modem and connect the other end to the
Ethernet port of a PC. Use a Category 5e or Category 6
Ethernet cable with RJ-45 connectors to ensure Gigabit
Ethernet speeds (when the computer supports it).
3. Connect an RJ-11 phone cable (supplied) to the TEL1 port on
the modem (when provisioned for voice service as specified by
the service provider), and connect the other end to the phone
port of the telephone. If voice service is not provisioned
through the service provider, telephone service is not available.
4. Connect the power adapter (supplied) to the POWER port.
Connect the other end to a power outlet.
1
UBC1310BA10
RJ-45
Analog Phones
RJ-11
Cable/RF
Device must be installed
vertically to obtain optimum
wireless performance.
2
1
3
4
Connect a PC or Ethernet enabled device (wireless
switch or router). A PC should be connected for
initial device installation and configuration.
