Ubee Interactive
Introduction
Ubee DVW2110 Wireless Voice Cable Modem and Router Subscriber User Guide • December 2011
7
1.8
Understanding the DVW2110 Back Panel
The image below and the following table describe the device’s back panel connections.
Label
Description
POWER
Connects the device’s power adapter to the device. WARNING: Use only
the power adapter shipped with this device. Failure to do so may cause
damage to the device.
TEL
Connects an analog telephone using a standard RJ11 cable. Telephone service must
be enabled through the service provider to use home telephony.
ETHERNET
Connects an Ethernet device such as a computer, gaming console, or a router/hub
to the Internet using a standard RJ45 Ethernet cable. See the
Understanding the
Customer Premises Network on page 3
for more information.
RESET
Button disabled. An administrator can reset the device to factory defaults through the
Web user interface or the management information base (MIB).
CABLE
Connects the device to the cable wall outlet or a cable splitter connected to the wall
outlet.
WPS
Connects a PIN-protected Wi-Fi device to the cable modem when the Wi-Fi
Protected Setup method is used. When the WPS button is pushed or triggered
through the device’s Web UI, an LED on the top-front of the device flashes for four
minutes until a PIN is entered from the wireless client, such as a laptop computer,
that wants to connect. After a Wi-Fi client attaches successfully, the LED remains on
for five minutes, and then turns off. Refer to
Understanding the Wireless Menu on
page 51
for more information.
