Zone
no.
Symbol on
display
Description
1
By pressing here you get access to the information menu; here one can only read out values. It is not possible to
change these values.
By pressing here you get access to the settings menu. In this menu you can change the various values. For all
setting values of standard appliance ( Setting values standard appliance page 52). The Plus version of the
appliance has various setting values ( Setting values appliance with Plus pcb page 55).
Caution: Incorrect settings can disrupt the operation of the appliance!
Use these arrows to go up or down the various menus or to increase or decrease the values of the relevant
settings.
This arrow takes you back one step in the menu.
This takes you back to the main screen.
2
Filter message symbol; this is only shown if the fi lter has to be cleaned or replaced. See chapter "Filter cleaning"
( Cleaning fi lter page 30) for more information.
This symbol is only shown if a fault has occurred in the appliance; see chapter Faults ( Fault analysis page 27)
for more information.
20 | Art.-nr.:
616711-A
Ubifl ux Vigor W225 | 21
6 Display
6.1 General explanation of control panel
A display with touchscreen is located at the front of the appliance. This display is used to operate the appliance and
to provide the user with information about the status of the appliance. When the mains power is switched on, the
software version is fi rst shown; the main screen is then displayed.
Main screen
6.2 Display layout
The screen is divided up into 6 zones where various symbols/displays can be shown per zone.
Layout of main screen
* Filter message and fault message are located in the same place on the display; fault display has a higher priority, and so will always be shown
fi rst even when there is an active fi lter message!
The factory setting of the menu is English.
The desired language/ date & time can be modifi ed in the settings menu ; for this, please refer to the settings value table ( Setting values
page 51) step number 15.1 to step number 15.10.
1.
Current time
2.
Info connections (only displayed if applicable)
3.
Current date
4.
Set ventilation fl ow rate; the red bars indicate the selected ventilation fl ow rate. In this example the active
ventilation fl ow rate is 100 m
3
/h
5.
Active control
6.
Filter message (only displayed if applicable)*
7.
Fault (only displayed if applicable)*
8.
Access to settings menu
9.
Access to information menu
1.
Navigation screen
2.
Notifi cation screen
3.
Screen with main function
4.
Connectivity information
5.
Time
6.
Date
The various symbols can be shown on the display. This depends on the screen that is shown, the version of the
appliance and any connected accessories.
