AV-30-E Service Bulletin Software Upgrade 1.1.0
UAV-1005261-001 Rev A
8.2 Additional Required Equipment
AV-Link is designed to interface with an existing
advantage of the AV-Link the following equip
AV-30-E 3” Display
8.3 Mounting
AV-Link is mounted in series between the AV
Connector.
8.3.1 Remove AV-30 From Instrument Panel (Optional)
It may be necessary, because of space limitations, to remove the AV
unit in order to perform AV
remove the four [4] screws that attach the AV
panel. Pull unit down to a workable position. Note that it may also be
necessary to disconnect the Pitot and Stat
Ensure that the lines are properly labeled before disconnecting.
8.3.2 AV-30 Backshell Connector Removal
Using a flat screwdriver, loosen the two [2] screws that hold the Backshell
Connector to the DB-15 connector on the back of the
Backshell Connector is free to detach from the AV
bonding/ground strap attached to the Backshell Connector.
8.3.3 AV-Link Attachment
Do not attempt to remove the two [2] captive Jack Screws from the AV
Housing. Attach the AV-Link to the back of the AV
into the DB-15 connector on the back of the AV
the Jack Screws as they will stop against the screw bosses on the AV
E Service Bulletin Software Upgrade 1.1.0
1 Rev A
Additional Required Equipment
Link is designed to interface with an existing AV-30-E display. To take
Link the following equipment is required.
Link is mounted in series between the AV-30 and the AV-30 Backshell
30 From Instrument Panel (Optional)
It may be necessary, because of space limitations, to remove the AV
der to perform AV-Link installation. Using a Phillips screwdriver,
remove the four [4] screws that attach the AV-30 to the aircraft instrument
panel. Pull unit down to a workable position. Note that it may also be
necessary to disconnect the Pitot and Static lines to bring into reach.
Ensure that the lines are properly labeled before disconnecting.
30 Backshell Connector Removal
a flat screwdriver, loosen the two [2] screws that hold the Backshell
15 connector on the back of the AV-30 until the
Backshell Connector is free to detach from the AV-30. If present
attached to the Backshell Connector.
Link Attachment
Do not attempt to remove the two [2] captive Jack Screws from the AV
Link to the back of the AV-30 by inserting the unit
15 connector on the back of the AV-30. Do not push against
the Jack Screws as they will stop against the screw bosses on the AV
15
display. To take
30 Backshell
It may be necessary, because of space limitations, to remove the AV-30
Link installation. Using a Phillips screwdriver,
30 to the aircraft instrument
panel. Pull unit down to a workable position. Note that it may also be
ic lines to bring into reach.
Ensure that the lines are properly labeled before disconnecting.
a flat screwdriver, loosen the two [2] screws that hold the Backshell
30 until the
present, leave the
Do not attempt to remove the two [2] captive Jack Screws from the AV-Link
by inserting the unit
30. Do not push against
the Jack Screws as they will stop against the screw bosses on the AV-30
