Service Bulletin
26
UAV-1005757-005 Rev A
5.
Rotate the knob until you see “SW PART NUM”. Confirm part number
matches that shown in Table 5-1 Software Update Files.
6.
Rotate the knob until you see “SW VERSION”. Confirm version matches
that shown in Table 5-1 Software Update Files.
7.
Rotate the knob until you see “SW CHECKSUM”. Confirm checksum
matches that shown in Table 5-1 Software Update Files. Note that the
checksum is not case sensitive.
If all software fields match, continue with these instructions. Otherwise,
contact uAvionix Support.
The following sections detail new Installation Menu options and should be
reviewed and set appropriately for your aircraft. Access the Installation
Menu and rotate the center knob to select these settings.
9.1 SERIAL 2
Follow the procedure in Section 9 to access the Installation Menu. Rotate
the center knob unt
il “SERIAL 2” is displayed. If this value is changed to
“AEROCRUZE” or “PRO PILOT”, the AV-30 will communicate with an
autopilot. The SERIAL 2 setting is verified if the AUTOPILOT setting in the
PUSH-SET rotary knob menu is visible. Push and release the center knob
five times to see the AUTOPILOT setting. See the AV-
30 Pilot’s Guide
UAV-1004233-001 Rev F for further details.
9.2 SERIAL 3
Follow the procedure in Section 9 to access the Installation Menu. Rotate
the center knob until “SERIAL 3” is displayed. SERIAL 3 will be set to
“AVLINK” after update. This will enable the AV-Link-E MFD screen. If no
AV-Link-E is installed, this setting should be set to NONE.
9.3 SERIAL 4
Follow the procedure in Section 9 to access the Installation Menu. Rotate
the center knob until “SERIAL 4” is displayed. SERIAL 4 will be set to
“NONE” after update. If you change the value to AVMAG, this will enable
the AV-Mag external magnetometer and its associated installation menus.
If no AV-Mag is installed, this setting should be set to NONE.
