7
TOOL LOADING – BOTTOM LOAD DESIGN
1. Disconnect air supply.
2. Unlatch and slide rearward the magazine
3. Insert fasteners and slide magazine forward to
engage.
4. Connect air supply to the tool.
TOOL LOADING – REAR LOAD DESIGN
1. Disconnect air supply.
2. Insert a strip of fasteners into the magazine
from the rear slot.
3. Pull the nail pusher backwards gently allowing the
fasteners to slide forward. Release the nail
pusher to engage the fasteners.
4. Connect air supply to the tool.
8
TROUBLESHOOTING
Stop using the tool immediately if any of the following problems occurs. Serious
personal injury could occur. Necessary repair or replacement must be carried out by
a qualified and trained technician of an authorized service location.
PROBLEM
CAUSE
TROUBLESHOOTING
Tool not lubricated.
Lubrication.
Broken spring in cap
assembly.
Replace spring.
Weak drive.
Exhaust port in cap is
blocked.
Clean or replace dam-
aged internal parts.
Worn or damaged nose.
Replace nose.
Damaged driver.
Replace driver.
Incorrect size of fasteners. Use recommended
fasteners.
Bent fasteners.
Replace with new
fasteners.
Tool jams.
Magazine or nose screws
are loose.
Tighten screws.
Fasteners jammed in
magazine or discharge
area.
Inspect and clean
magazine.
Piston shaft is damaged.
Replace piston shaft.
Tool does not fire.
Air pressure too low.
Check/increase air pres-
sure.
