U.S. Solid Ba+ery Spot Welder USS-BSW00007 Manual, Version 4.1, 2022.8.16
• Only charge the machine with the original power adapter. Otherwise the
machine may not be charged or may break.
• ‘MT’ mode is recommended for new user and the ‘AT’ welding mode is
suitable for high-efficient welding work when familiar with the welding
process.
• Apply appropriate pressure on welding pieces according to different
material and thickness.
• Put enough pressure on two welding electrodes to get the welding pieces
and welding surface fully contacted, otherwise the welding pieces will be
penetrated and cause a bad welding effect.
• Apply enough and uniform pressure on two welding electrodes to avoid
bad welding effect and large sparks.
• keep welding pieces clean (no oxides, stain) to avoid bad welding.
• Clean oxides on the welding pins/electrodes regularly and replace them
when necessary. This ensures good electric conduc?vity to get an op?mal
welding effect.
• The lubrica?ng oil can be smeared on welding pins/electrodes to prevent
oxidizing.
• Keep welding pins long enough for pulling out later.
• Plug in firmly when replacing new welding pins/electrodes for good
electric conduc?vity.
• Only use the original welding pins/electrodes from U.S. Solid.
• Do not take part and modify the machine. Doing so may cause a short
circuit and fire danger.
• Do not use the machine if lacking related experience and knowledge.
• Do not use the machine in inflammable, explosive or wet environments.
• Keep the product out of reach of children.
19
