Precautions
This manual should be made available to all users of this equipment. For
best
results, and for maximum durability of the equipment, carefully read
and follow
all instructions.
The tape dispenser includes sharp metal parts, please be careful when
using the product.
Do not damage the cable
s
, such as processing the cable, bending the
cable, pulling and
s
trapping the cable, placing heavy objects
on the cable or
cutting with scissors.
Do not use the tape dispenser
if
cable or plug has
damage
s,
or the socket
outlet
is
loose.
Once the cable
is
damaged, do not
disassemble or replace
it by
yourself
,
but
return
the tape
dispenser to factory for after-sales service.
When stop using
the
tape dispenser, or repairing and inspecting the tape
dispenser, please pull out the power plug from the outlet
first
.
Do not touch the cable or socket with wet hands.
When repairing or
storing, please avoid
water or moisture
,
and
place
the
tape dispenser where
children can not reach and well ventilated.
When the tape is rolled into the feed rollers, please turn off the power
switch(OFF) before removing the tape.
Trouble caused by users’
split or assembly, the tape dispenser will be not
guaranteed.
The upper & lower blade set is easily sticked by adhesive tape, which will
cause the cutting not so smoothly, please clean the blade set on time.
Coat the Blade set with some oil or lubricant can improve the life
effectively.
When the tape feeding is curly, rotate the reel adjustment keys in
clockwise direction or replace the reel.
When the AUTO Feed does not work, please check whether the sensor
part is clean or not .
Troubleshooting
1.
Problem:The tape will not be released automatically
or the tape will be sluggish.
Solution:
Induction
is
too high, u
se a Phillips
screwdriver to adjust the
bottom plate induction,
and adjust it in the - direction
about
1MM.
2.
Problem: Continuously cut tape, or cut a piece and
then alarm
.
Solution:
Induction
is
too low, us
e a Phillips
screwdriver to adjust the
bottom plate induction,
and
adjust it in the + direction
about 1MM.
3.
Problem: Excessive indentation on the tape
Solution:
Pressure is too large, a
djust the knob on the
top of the machine to
the S direction by half a turn to
one turn
4.
Problem:
Tape does not come out when cutting
Solution:
Pressure is too small, a
djust the knob on the
top of the machine to
the
H
direction by half a turn to
one turn
.
5.
Problem: The tape does not come out smoothly or
the glue outlet is blocked with the tape
Solution:
Replace the s
eparating
r
oller
r
ing
.
6.
Problem: Tape does not cut completely
Solution:The blade is worn or the shrapnel pressure is
too small, replace the blade or adjust the shrapnel
pressure
.
