Guide Bar and Diamond Chain Installation
SET-UP
Air Powered Chain Saw
STEP 1
Loosen side cover nut an remove side
cover.
STEP 3
Mount the diamond chain on the guide bar
starting at the drive sprocket and continue
over the guide bar nose.
STEP 4
Install the side cover and ensure chain
adjustment pin engages hole in bar. Do
not fully tighten side cover until after chain
is properly tensioned.
STEP 2
Place bar onto saw chassis and ensure the
bar sits over bar spacers on stud bolts.
STEP 5
Make sure all the drive links are inside
the guide bar groove then lift the bar nose
and tension the chain by turning the screw
clockwise.
STEP 6
Before cutting, check for proper tension by
pulling the chain around the bar by hand. If
you cannot easily pull by hand, the chain is
too tight and needs to be loosened slightly.
Be aware that the guide bar rails may
develop sharp edges over time so always
pull the diamond chain by the diamond
segments.
© 2011 ICS, Blount Inc.
F/N 70944 May 2011
TITLE
633GC / 633F4 OPERATOR’S MANUAL
4
SYMBOLS & LABELS
THE FOLLOWING SYMBOLS & DEFINITIONS ARE FOUND THROUGHOUT THIS MANUAL AND
ARE DESIGNED TO MAKE YOU AWARE OF POTENTIAL HAZARDS OR UNSAFE PRACTICES.
A potentially hazardous situation exists which, if not avoided,
could result in death or serious injury.
A potentially hazardous situation exists which, if not avoided,
may result in minor or moderate injury or property damage.
A potential situation exists which, if not avoided, may result in
product or property damage.
THE FOLLOWING SYMBOLS & LABELS MAY BE FOUND IN THIS MANUAL OR ON THE SAW
Read the operator’s manual carefully and understand the
contents before you use this equipment.
Always use:
• Protective helmet
• Ear protection
• Protective glasses or full face protection
Wear hand protection
IMPORTANT
WARNING
CAUTION
6
THE FOLLOWING SYMBOLS AND DEFINITIONS ARE FOUND THROUGHOUT THIS
MANUAL AND ARE DESIGNED TO MAKE YOU AWARE OF POTENTIAL HAZARDS OR
UNSAFE PRACTICES.
A potentially hazardous situation exists which, if not
avoided, could result in death or serious injury.
A potentially hazardous situation exists which, if not
avoided, may result in minor or moderate injury or
property damage.
A potentially hazardous situation exists which, if not
avoided, may result in product or property damage.
THE FOLLOWING SYMBOLS & LABELS MAY BE FOUND IN THIS MANUAL OR ON THE TOOL.
Read the operator’s manual carefully and understand the
contents before you use this equipment.
Always wear a protective helmet
WARNING
CAUTION
IMPORTANT
Always wear protective glasses or full face protection
Always wear hearing protection
Always use ground fault protection
Always wear breathing protection
Symbols & Labels
A potentially hazardous situation exists which, if not avoided, could
result in death or serious injury.
A potentially hazardous situation exists which, if not avoided, may
result in minor or moderate injury or property damage.
A potentially hazardous situation exists which, if not avoided, may
result in product or property damage.
