A
B
C
D
E
A VACUUM
B WARNING
INDICATOR
C PUMP
D HEAT
E BOOSTER
HEAT
SOLVENT HEATING
Turn on the Heater Switch
(D)
. The Booster Heat switch
(E)
must be all the way off (turned counterclockwise until it ‘clicks’ off) or the machine will
not heat at all.
WATER HEATING
Turn on the Heater Switch
(D)
. Turn on the Booster Heat Switch
(E)
to the desired temperature, 130° - 212°F (55° - 100°C)
NOTE:
Booster Heat will not work unless the Heat switch is on.
WATER ONLY, NO SOLVENT (E)
This indicator light
(B)
illuminates when the Booster Heat switch
(E)
is turned on. It is a reminder that the Booster Heat will only work with water-
based solutions.
CAUTION
USE A RAG TO DISCONNECT BRASS FITTINGS AFTER USING THE BOOSTER HEAT. THE FITTINGS CAN GET VERY HOT AND MAY
CAUSE MINOR BURNS.
AUTO VAC SHUT-OFF
When the recovery bucket is full, the vacuum motor will automatically shut off. The
fl
oat in the bucket may not be raised by foam. Defoamer must
always be used to avoid water damage to the vacuum motor.
SOLVENT SENSING SYSTEM
This unique, patented system determines whether there is solvent or water-based solution in the tank. If solvent is used, the sensor will
automatically prevent heating above 140 °F. To prevent accidental over-heating of solvent, the use of the Booster heat switch - with solvent in the
tank - will cause the entire heat system to shut off.
revised 6/12
A - 6
PB111 - 56041875
12/10
INSTRUCTIONS FOR USE
A - ENGLISH
https://harrissupplyind.com - To Order Parts Call 608-268-8080
