Page 3
For technical questions, please call 1-800-444-3353.
SKU 5223
2 or 3 Jaw Puller Adapters (6 or 10). Thread the
adapter onto the Spindle until non-threaded end
of the Spindle exits the Adapter.
To grip the work piece internally, claws of the
3.
Jaws should be facing outward.
Back-off the Lock Nut (3) to permit the jaws to
4.
be attached to the workpiece. Turn the Lock Not
forward, causing the claws to expand and grip
the work piece firmly. Tighten the fasteners.
Push the Slide Hammer towards the work-piece,
5.
and then forcefully pull it back towards the cross
par end. Repeat as needed, and adjust the
required force based on job requirement or your
physical ability.
operation
(dent pulling)
Attach hollow end of the Lock Nut onto Spindle.
1.
Drill a 1/8” hole into the center of the dent.
2.
Place the Self-Threading Screw (13) through the
3.
Dent Puller Adapter (7). See Figure 5.
Thread the Self-Threading Screw into the drilled
4.
hole using a #2 Phillips screwdriver.
Thread the Spindle into the Dent Puller Adapter.
5.
Thread the Lock Nut (3) against the Dent Puller
Adapter and hand tighten. See Figure 5.
Push the Slide Hammer toward the object to be
6.
pulled. Gently pull the Slide Hammer toward the
Handle Cross Bar.
caution!
7.
Do not use excessive force when
pulling dents. Sheet metal can easily bend.
Repeat Step 5 until dent has been pulled out.
8.
operation
(hook/thread pulling)
Identify the lip area you will be inserting the Pull
1.
Hook (5) into or onto.
Thread the Puller Hook onto the end of the Slide
2.
Screw. See Figure 6.
Place the Puller Hook tip onto the edge of the lip
3.
of object to be pulled.
Push the Slide Hammer toward the object to be
4.
pulled. Gently pull the Slide Hammer toward the
Handle Cross Bar.
Repeat Step 4 until object has been pulled out.
5.
The Screw Adapter (8) can be used for larger
6.
cross sections, heavier sheet metal, and
concentrated deep dents. See Figure 7.
Follow the Steps 1-5 until threaded object has
7.
been pulled out.
Figure 4
Spindle (11)
Lock Nut
(3)
Jaws (4)
3-Jaw
Puller
Adapter
(10)
Screw
and Nut (1)
Figure 5
Lock Nut
(3)
Self-Threading
Screw (13)
Dent Pull
Adapter (7)
Lock Nut
(3)
Figure 6
Puller Hook (5)
Figure 7
Lock Nut
(3)
Screw Adapter (8)
Spindle (11)
