Page 2
For technical questions, please call 1-800-444-3353.
SKU 5223
Slide the plane end of the Slide Hammer (12)
1.
onto Spindle (11). See Figure 1. Insert Cross
Bar (9) into eyelet at the end of the Spindle.
note:
2.
The Lock Nut serves as a Hammer Stop
for the forward motion of the Slide Hammer (12)
and should be assembled prior to every task that
requires a pulling attachments. See Figure 1.
pulling operation
(hub/axle/drum)
Thread hollow end of Lock Nut (3) onto Spindle.
1.
Jack up the vehicle according to your vehicle’s
2.
Owner’s Manual. Make sure the car is safely
supported by Jack Stands (not included).
Remove the wheel and tire and any nuts, bolts or
3.
accessories (such a brake calipers) that may get
in the way of removing the Hub/Axle/Drum.
Bolt the Rear Axle Puller (2) onto the Hub/Axle/
4.
Drum using the original lug nuts. If your vehicle
has a four-bolt Hub, match the Rear Axle Puller
to two axle bolts. If it has a five-bolt Hub, match
to three axle bolts. Tighten the lug nuts.
Remove the Spindle (11), Handle Cross Bar (9),
5.
Lock Nut and Slide Hammer from the carrying
case. Assemble according to Figure 1.
Thread the Spindle into the Rear Axle Puller hub
6.
until its non-threaded end exits the hub. Turn
the Lock Nut (3) forward until it seats against the
Rear Axle Puller hub and hand tighten.
Push the Slide Hammer towards the vehicle.
7.
Forcefully pull the Slide Hammer toward the
Handle end of the Slide Screw.
Repeat Step 6 until the Hub/Axle/Drum comes
8.
off.
Jaw operation or extraction
(external grip)
Attach the hollow end of the Lock Nut (3) onto
1.
the Spindle.
Depending on the application or requirement, use
2.
the Screws and Nuts to attach the Jaws to the
2 or 3 Jaw Puller Adapters (6 or 10). Thread the
adapter onto the Spindle until non-threaded end
of the Spindle exits the Adapter.
To grip the work piece externally, claws of the
3.
Jaws should be facing inward, as shown in
Figures 3 and 4.
Clamp the Jaws onto the object to be pulled.
4.
Turn Lock Nut (3) clockwise against the end of
the Jaws, forcing them apart, causing the claws
to be pushed inward against the work piece.
Tighten the Screws and Nuts firmly.
Push the Slide Hammer towards the work-piece,
5.
and then forcefully pull it back towards the cross
par end. Repeat as needed, and adjust the
required force based on job requirement or your
physical ability.
Jaw operation or extraction
(internal grip)
Attach the conic end of the Lock Nut (3) onto the
1.
Spindle.
Depending on the application or requirement, use
2.
the Screws and Nuts to attach the Jaws to the
Lock Nut
(3)
Spindle
(11)
Figure 1
Slide Hammer (12)
Figure 2
Rear Axle Puller (2)
Slide Hammer
(12)
Cross Bar (9)
Figure 3
Jaws (4)
Lock Nut
(3)
Spindle (11)
2-Jaw
Puller
Adapter
(6)
Screw
and Nut (1)
