Page 5
SKU 47860
4.
Attach the test adapter
(continued)
.
Bosch Systems:
a. Remove the bleeder screw from the caliper.
b. Thread the desired Adapter into the caliper only until seated (primary or secondary
test points).
5.
Attach the Gauge Assembly hose to the Adapter and tighten.
6.
Turn the ignition on to start the engine and run the pump.
7.
Connect a short, clear tube to the Bleed Valve, and the other end in a container.
Alternately, place a rag over the Bleed Valve to prevent the brake fluid from spraying.
8.
Open the Bleed Valve until all air is evacuated. Close Bleed Valve.
Verify proper system pressure on the Pressure Gauge. Review the vehicle service
manual procedure for testing hydraulic pressure.
9.
Turn the engine off.
10.
Depressurize brake system by pumping brake pedal (to the floor) at least 20 to 40
times.
When you feel a pronounced increase in pressure against your foot, pump the pedal
three more times.
Caution: Never disconnect the brake pressure testing components while under pres-
sure.
11.
Remove the brake pressure testing components.
Clean and store them in the case.
Maintenance
1.
Thoroughly clean all Brake Test Pressure Kit components after each use.
2.
Store all components in the tester’s kit case.
3.
Clean up all spilled brake fluid from vehicle and floor.
Never run a vehicle’s engine in an enclosed garage or any other type
of enclosed structure.
Carbon Monoxide, an odorless, colorless
deadly gas may accumulate and cause serious injury or death.
Содержание 47860
Страница 7: ...Page 7 SKU 47860 Parts Drawing...
