Integrated Technical Vision Ltd.
2
Mounting
We recommend to install reader on the wall next to the door
from the lock side. Reader should be installed in the way that
is convenient for all users. Make small recess or hole
(diameter is 14 mm) to connect cable under the reader's case.
Do not
place the reader on metal surfaces, since it causes
decreasing of read range. If more than one reader is used in
the system, place them not closer than 20 cm one from
another to eliminate the effect of double reading.
Reader Installation
−
Loosen the screw at the bottom of the reader.
−
Remove the top cover, remove the back plate.
−
Mount the back plate of reader on the wall using the fixtures
provided (see fig. 2).
−
Prepare all wires for connection and connect them to the reader
in according to Table 1 and User Manual of the access control
panel to be utilized.
−
Insert the reader in the back plate (see fig.
3).
−
Put the top cover and tighten screw at the
bottom of the reader.
−
Ensure that all locking tabs are securely
engaged.
The Reader Operation
RFID Card Code Reading
Code is read when a valid RF ID is passed.
Card code reading is annunciated by embedded buzzer and LED lamp according to the interface type
and annunciation mode (see Section «Data transfer and Annunciation»).
Subsequent reading will be available in 0.8 sec only after card removed from the reader sensing area.
U-Prox ID code reading
Download and install mobile software U-Prox Mobile ID. It enables to receive, store U-Prox ID and
transfer ID code between reader and smartphone.
Get the U-Prox ID identifier from U-Prox Desktop localy, or remotely by e-mail
or QR code
.
Hold mobile device near the reader (standard distance is 10-40 cm) and press
the button "Open" in app.
The application will execute
data exchange. The card code reading is
annunciated by embedded buzzer and LED according to the interface type and
annunciation mode (see Section «Data transfer and Annunciation»)
Hold Mode
Reader turns to the hold mode while yellow wire is shorted to ground. In this mode, reader does not
read cards that reduces the current consumption to 25 mA.
Relay or an open collector transistor can switch on hold mode.
It is prohibited to supply the external voltage to the yellow wire!
Data transfer and Annunciation
Reader has bicolour LED indicators and buzzer.Their control depends on the interface type.
Wiegand Interface
Engaging of LED and buzzer is automatic or by grounding of corresponding wire (see Section
«Wiring»)
Figure 3
U-Prox ID
Figure 2