PAGE 3 OF 5
0614 IH-974
loading mEdia
caUtion: when loading media, remove all
jewelry that could come into contact with the
printhead or other printer parts.
LOADInG rOLL MEDIA In tEAr-OFF MODE
1. Press printhead release latch to open printhead
assembly. Lift printhead until it latches open.
(See Figure 1)
2. Slide out media guide. (See Figure 2)
3. remove and discard any tags or labels that are
dirty or are held by adhesives or tape.
(See Figure 3)
4. Flip down media supply guide. (See Figure 4)
5. Place roll of media on media supply hanger. Push the
roll as far back as possible. (See Figure 5)
6. Flip up media supply guide. (See Figure 6)
7. Slide in media supply guide until it touches the edge
of the roll. (See Figure 7)
8. Feed media under dancer assembly, upper media
sensor, and ribbon sensor. (See Figure 8)
Dancer
Assembly
Upper Media
Sensor
ribbon Sensor
Media Path Diagram
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Media Guide
