USER GUIDE
u-line.com
Remove Fan and Cover
1. Remove any product from the unit.
2. Remove unit from cabinetry to access rear.
3. Disconnect power to the unit.
4. Remove back panel from unit.
5. Disconnect fan electrical connection at rear of unit.
Air F
low
Remove Fan and Cover
Evaporator Fan Replacement
Should the evaporator fan need to be replaced follow the
steps below.
starting
.. Remove the front cover grille. Take out the two
upper and two lower screws. Disconnect the power cord
from the back of the display / control board, then set the
grille aside.
2. Remove the evaporator box cover. Take out the four
long screws and set the cover aside, exposing the
evaporator compartment.
3. Remove the evaporator air deflector cooling baffle by
sliding it out and set aside.
1.
Disconnect power from the unit before
4. Remove (4) screws to detach fan assembly from
assembly from mounting bracket assembly.
5. Grab ahold of each fan assembly and push toward
the interior of the unit to remove the motor shaft from
the rubber gasket.
48
Содержание UCBR552-SS01A
