To raise and lower the Light Hood, wrap one hand around the bottom
of the Light Post just above the Grow Deck. Grasp the upper part of
the Light Post with your other hand and push up to raise the Light
Hood or push down to lower the Light Hood. The Light Post will move
up or down a notch at a time with a little pressure, or you can move it
up or down several notches at a time
with more pressure.
When planting a new Seed Pod Kit,
the Light Hood should be set to
the lowest possible position. For
instructions and tips about when to
raise (or not to raise) the Light Hood,
refer to Gardening Tips (on flip side)
and/or Seed Pod Kit Instruction
booklet included with each seed kit.
How to Raise and Lower
the Light Hood
}
Order extra Seed Pod Kits and Accessories at www.aerogarden.com
LED Light Hood & Base
Bowl & Grow Deck
Seed Pod Kit
Included in Package
- Front View -
Quick Setup Guide
Keep this Guide!
Simple Steps to Get Your AeroGarden Up and Growing
(No tools required)
Welcome to the world of indoor gardening!
AeroGarden Harvest Model numbers: 100640 - BLK/WHT Electrical Rating: 120V~60Hz, 0.3A
AeroGarden Harvest Elite Model number: 100645 - BSS
Electrical Rating: 120V~60Hz, 0.3A
Date Code
2 Easy Steps
To Get Your AeroGarden Up and Growing
For more details on planting, growing and
harvesting your AeroGarden, please turn the page.
➠
CONGRATULATIONS!
Your garden is ready to grow.
It really is that easy!
Bowl
Base
Light Post
Grow Deck
LED Light Hood
Note: Do not place beneath
under-cabinet lights.
Place Your Garden...
Plug Pump Power
Cord into Base
2
Pump Power Cord
(back view)
Check to make sure that
Pump
power cord is plugged
into the connector at the
back of the base.
Push up to raise
Light Hood,
push down to
lower Light Hood.
Harvest
Harvest Elite
When using this AeroGarden electrical furnishing, basic precautions should always be followed, including the following:
Read all instructions before using this AeroGarden furnishing.
1. To reduce the risk of electric shock, the AeroGarden has a specific plug.
Do not change the plug in any way.
DANGER
– to reduce risk of electric shock:
2. Always unplug the AeroGarden from electrical outlet before cleaning or
changing Grow Lights (light bulbs).
WARNING
– to reduce risk of burns, fire,
electric shock, or injury to persons:
3. Unplug AeroGarden from outlet before putting on or taking off parts.
4. Close supervision is necessary when an AeroGarden is used by or near
children, invalids, or disabled persons.
5. Use AeroGarden only for its intended use as described in the instructions. Do
not use attachments not recommended by manufacturer.
6. Never operate AeroGarden if it has a damaged cord or plug, if it is not
working properly, if it has been dropped and damaged, or if it has been
dropped in water. If any of these conditions occur/exist, contact www.
AeroGardenSupport.com or your country’s local distributor for instructions.
7. Keep cord away from heated surfaces.
8. Never operate furnishing with air openings blocked. Keep air openings free
of lint, hair, and the like.
9. Never drop or insert any object into any electrical openings.
10. Do not use outdoors.
11. Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
12. Do not touch moving parts or hot parts such as pumps, lights, reflective
surfaces, and the like.
13. To disconnect, remove plug from outlet.
14. Do not place or submerge base, cord, plug, or Light Hood in water or other
liquid to clean it.
15. Do not allow water to contact hot LED Grow Lights.
16. Use only approved and supplied parts and accessories. Use only AeroGarden
LED Grow Lights with this AeroGarden model. Use of any other kind of
accessory is not recommended. Replacement parts can be ordered from
www.AeroGarden.com
17. Do not use AeroGarden for other than intended purpose.
18. This product is intended for household and residential use only. This product
is not approved for commercial applications.
19. If supply cord is damaged, it must be replaced by manufacturer, its service
agent, or similarly qualified technician in order to avoid a hazard.
20. Electrical wiring must be in accordance with local regulations.
21. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of appliance by a person responsible for their safety.
22. Children should be supervised to ensure they do not play with the appliance.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
•
On a sturdy, water-tolerant surface
•
Near a standard electrical outlet, per local
regulations
•
In a 65-80°F (16-26°C) environment
(optimal)
•
Away from reach of children or pets
•
Away from direct sources of
heat
(e.g., stove,
furnace vents)
or
cold
(e.g., window drafts, A/C vents)
•
AeroGardens do not need additional light or a
sunny window. In fact, too much direct sunlight
can overheat your plants
Veggies
16 Hrs
Herbs
18 Hrs
24 Hrs
Add
Nutrient
Add Water
SELECT
When
Add Nutrient
light is on,
add nutrients,
then press
Reset button
To set
ON
time, turn
lights on. Then hold
Lights
button 3 seconds
Harvest Elite
Control
Panel
Warning:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Increase the separation between the equipment and receiver.
—Consult the dealer or an experienced radio/TV technician for help.
Set Bowl into Base
1
Check to be sure
that Bowl is securely
seated in Base and
that Grow Deck is
properly aligned on
Bowl.
