PAGE 3 OF 17
0320 IH-5806
LOADING INSTRUCTIONS
NOTE: Paper towel roll should be inserted into
the dispenser with the black core insert on the
left hand side of the roll.
1. Push right roll holder arm to the right and insert black
core into the left holder arm. Release right holder
arm slowly to ensure that paper towel core fits
properly into right holder arm. (See Figure 10)
2. Feed paper down into the roller so the paper is in
front of the roller. (See Figure 11)
3. Locate the paper feed button on the right side of
dispenser and press down until paper feeds all the
way through the roller. If the roller is not catching the
paper, ensure the paper is fed down in between the
roller and the front of the dispenser. (See Figure 12)
STUB ROLL FEATURE
1. If low roll indicator light is flashing, the main roll is
small enough in diameter to be used as a stub roll
if desired. To use the low roll as a stub roll, remove
the roll from the holder arms and place it on the
lower set of holders located just above the battery
compartment. (See Figure 13)
2. Feed paper up over the roller and down between
the roller and the front of the dispenser. Insert new
full roll into main set of holder arms. (See Figure 14)
3. Feed paper from new roll down into the roller as
in Step 2 above. There should now be two sheets
of paper down by the roller. Press the paper feed
button to feed both sheets down through the roller.
Dispenser will dispense two sheets until stub roll is
depleted. (See Figure 15)
Tork
H1
PUSH
PUSH
Figure 10
PUSH
PUSH
Low Roll
PUSH
PUSH
Figure 13
Stub Roll
PUSH
PUSH
Figure 14
PUSH
PUSH
x 2
PUSH
PUSH
Figure 15
PUSH
PUSH
PUSH
PUSH
Figure 11
PUSH
PUSH
Figure 12
