U-Line SHOP-VAC H-8098 Скачать руководство пользователя страница 8

PAGE 8 OF 8 

0719 IH-8098

DAILY

1. 

Filter

 – Check cartridge filter for clogs or heavy 

soiling and replace if necessary. Ensure that correct 

filters are being used for the task – see Filters section 

of instruction manual. 

2. 

Collection Bag

 – If using collection filter bag, check 

to ensure that there are no rips or tears in the bag 

and that the bag is not full.

3. 

Tank

 – If vacuuming up wet or damp material, 

empty tank after use, as musty odors may occur if 

debris is left inside.

4. 

Extension Cord and Plug

 – Check extension cord 

and plug for any cuts or damage. If damaged, 

replace motor housing unit.

5. 

Motor 

– If there are unusual sounds or if poor 

performance occurs, the motor should be inspected 

immediately. Contact Uline Customer Service.

WEEKLY

1. 

Wands/Tools

 – Inspect wands and tool attachments 

for any damage. Replace if necessary.

2. 

Hose

 – Inspect hose for any damage and replace if 

necessary.

MONTHLY

1. 

Cleaning

 – Inspect and clean all areas of vacuum, 

including inside of tank. 

TROUBLESHOOTING

ROUTINE MAINTENANCE

π

  CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA

1-800-295-5510

uline.com

ISSUE

POSSIBLE CAUSE(S)

CORRECTIVE ACTION

Parts/accessories missing

1.  Packed in tank

1.  Check in tank.

Vacuum cleaner will not 

start

1.  No power at receptacle

2.  Defective switch

3.  Defective motor

1.  Check for power.

2.  Replace switch.

3.  Replace motor.

Dust discharging from 

exhaust

1.  Filter not installed or 

installed improperly

2.  Filter damaged

3.  Filter clogged or dust is  

too fine

4.  Filter not functional

1.  Properly install filter.

2.  Replace filter.

3.  Use more efficient filter.

4.  Clean and replace filter.

Loss of suction

1.  Loose hose connection

2.  Filter clogged

3.  Full tank

4.  Hole in hose

1.  Tighten hose connection.

2.  Clean or replace filter.

3.  Empty tank.

4.  Replace hose.

Static shock

1.  Dry environment 

2.  Relative humidity of air is low

1.  Add moisture to air (if practical, use a 

console or installed humidifier).

2.  This situation is temporary and does not 

affect use of vacuum cleaner.

Содержание SHOP-VAC H-8098









Отзывы: