PAGE 3 OF 21
0820 IH-8831
ASSEMBLY
1. Place pod onto floor nozzle post and slide it down until it clicks
into place. (See Figure 1)
2. Insert extension wand into pod until it clicks into place.
3. Slide accessory holder onto wand with post facing away from cord hook.
4. Insert handle assembly into wand until it clicks into place.
5. Insert flexible hose into connector on back of pod.
NOTE: For proper operation, ensure all parts are firmly clicked
into place.
1
2
3
4
5
Figure 1
SETTINGS
1. Press the Power/Surface switch at
the top of the pod. (See Figure 2)
2. Select surface setting:
• 0
Power Off
• I
Bare Floor (for bare floors
and small area rugs)
• II
Carpet
3. Suction Control offers variable
suction based on user's needs.
Rotate counter -clockwise to
reduce suction and increase
maneuverability on carpets. Rotate
clockwise to increase suction on
bare floors. (See Figure 3)
BRUSH ROLL INDICATOR LIGHT
Color of light indicates status of brush
roll. (See Figure 4)
• Solid Green: Brush roll is spinning
and working as it should.
• Solid Red: There is a jam in the
brush roll area. Turn vacuum off
and remove blockages in nozzle.
• No Light: The vacuum is off.
NOTE: For deep carpet cleaning per ASTM
F608 (embedded dirt in carpets), use setting II,
Carpet.
CLEANING MODES
UPRIGHT
To engage brush roll,
turn on power, then step
on floor nozzle and tilt
handle back.
(See Figure 5)
LIFT-AWAY
Press the red release
button on the side of
the pod. Gently hold
the nozzle to the floor
with foot and pull the
pod up. (See Figure 6)
OPERATION
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
