U-Line Origins 1075BEVS00, Инструкция по использованию и уходу

Страница: 10 / 20

8 1075BEV
To defrost:
1. Turn unit off.
2. Remove all products from the interior and prop the
door in an open position (2 in. (5 cm) minimum).
3. Allow the frost to completely melt naturally. Clean the
interior and all removed components using a mild non-
abrasive detergent and warm water solution applied
with a soft sponge or non-abrasive cloth.
NOTE: DO NOT use any solvent-based or abrasive
cleaners. They will discolor or damage the interior.
4. Dampen a soft sponge or non-abrasive cloth in clean
water and wipe down the cabinet interior and removed
components to remove any detergent residue. Rinse the
sponge or cloth in clean water and repeat as necessary
until the cabinet and components are clean.
5. When the interior is dry, turn unit back on.
Condenser Cleaning
INTERVAL - EVERY THREE MONTHS
To maintain operational efficiency, keep the front grille
free of dust and lint and clean the condenser every three
months. Depending on environmental conditions, more
or less frequent cleaning may be necessary.
WARNING
Disconnect electric power to the unit before
cleaning the condenser.
WARNING
DO NOT touch the condenser fins. The condenser
fins are SHARP and can be easily damaged.
IMPORTANT IMPORTANT
DO NOT use any type of cleaner on the condenser
unit.
Figure 6
1. Disconnect electrical power to the unit.
2. Remove the control knob (Figure 6) by pulling it
straight out, away from the grille.
3. Remove screws from the grille and remove grille. Save
the screws.
4. Clean the condenser coil (Figure 7) using a soft brush
with a “combing” action or vacuum cleaner. Do not
touch condenser coil.
Figure 7
5. Place the two hook-hinges (Figure 8) located on the
rear bottom side of the grille onto the front lip of the
unit base. Swing the grille up into position, and align
the screw hole on the grille to the grille screw hole on
the cabinet.
Figure 8
6. Insert the screw. Do not overtighten.
7. Reconnect power to the unit.
Leveling
It is important that units equipped with adjustable feet
are level, for proper door and ice maker (if equipped)
operation.
To level units with adjustable feet:
ULIN_0228_A
Condenser coil
ULIN_0153_A
Hook-Hinge
Hook-Hinge
Unit Base
Front Lip
Grille