PAGE 3 OF 15
0915 IH-1358
SET-UP INSTRUCTIONS CONTINUED
OPERATING INSTRUCTIONS
ADJUSTING BRUSH TANK WATER LEVEL
1. Loosen the screws on the water bottle brackets.
2. Move the water bottle brackets to a position that will
obtain the desired water level in the brush tank. Both
brackets should be in the same position. (See Figure 4)
NOTE: Lightweight tapes should be adjusted to
the low position, heavyweight tapes should be
adjusted to the high position.
3. Tighten the retaining screws on the water bottle
brackets.
ADJUSTING TAPE WEIGHT
1. Loosen the retaining screw.
2. Slide the tape weight forward to apply greater
pressure. Slide the tape weight backwards to apply
less pressure.
NOTE: Lightweight tapes will apply less water on
the tape. Heavyweight tapes will apply more
water on the tape.
3. Tighten retaining screw.
LOW
MEDIUM
HIGH
Figure 4
1. Pull the operating handle to the desired length on
the scale and release the handle.
2. When the handle returns to resting position, the tape
will be cut.
3. A mechanical stop on the side of the dispenser is
available if a known length will be used repeatedly.
4. The mechanical stop can be moved to the desired
position by loosening the knurled nut a half turn and
sliding up or down in the slot. Retighten knurled nut
once the desired setting has been found.
CAUTION! The knurled nut should never be
removed.
