PAGE 7 OF 25
0321 IH-9379
CONSIDERATIONS WHEN USING PROPULSION
• Always operate hand truck only as fast as safety
considerations allow.
• When turning tight corners, keep unit close to the
turn in the direction of travel. When turning right,
keep unit close to the turn on the right. When turning
left, keep unit close to the turn on the left.
• Use extra caution when moving loads on ramps or
moving loads in reverse
• While unattended, turn off unit.
• Do not drive hand truck through more than 2" of
water, and never submerge drive system or battery
box.
• Do not drive off curbs or ledges higher than one
inch. An aluminum walk ramp must be used to
overcome obstacles over one inch.
AFTER USE
1. Ensure hand truck is unloaded.
2. While unattended, turn unit off.
3. When batteries are installed, unit should be stored
and charged indoors and in a dry environment. To
maximize battery life and minimize charge time,
temperatures should be between 50º-100ºF.
4. Charge batteries as soon as possible upon returning
with unit from use. Charge daily or after every use in
a dry, well-ventilated area away from sparks, heat
and flames. Do not use an extension cord if possible.
Do not use charger if the cord is damaged.
OPERATION CONTINUED
MAINTENANCE
GENERAL MACHINE CARE
• Charge machine in a dry place, preferably at 50ºF
or warmer.
• Wash machine with warm, soapy water. Do not use
pressure washers.
• Do not drive through more than 2" of water, and
never submerge drive system or battery box.
• Drive system is lubricated for life, so no maintenance
is required for drive system.
• Keep pneumatic tires inflated to 20-25 psi.
PREVENTATIVE MAINTENANCE
AREA
INSPECTION FREQUENCY
PROCEDURE/NORMAL CONDITION.
Drive Wheels
Daily
Inspect wheels and tires for wear and
cracks.
Keep pneumatic tires inflated to 20-25 psi.
Fasteners
Daily
Tighten any loose hardware.
Battery
Charging
Daily
Orange or green charging light should turn
on when charging.
Casters
Daily
Inspect for wear; clean dirt and debris.
Transaxle
Daily
Transaxle should be kept free and clear of
debris.
When stored, transaxle lever should be kept
in powered mode with power off to keep
unit from rolling freely.
