PAGE 4 OF 15
0321 IH-7811
7. Set the unit upright and tighten all nuts and bolts
around the entire unit.
8. Insert the shelves (4)
at desired levels.
(See Figure 7)
NOTE: To place
the shelves, tilt
the shelf slightly
to the left or right
before inserting
into the unit.
9. Attach the left door (8) to the unit by placing the
door on the hinges, aligning the hinge holes,
dropping the hinge pins into the slots, then placing
the flat end of a screwdriver on the hinge pins and
tapping them in with a hammer. (See Figure 8)
10. Attach the right door (9) to the unit the same way
the left door was attached. (See Figure 9)
NOTE: If having
issues with doors
aligning, it may
be due to cabinet
not sitting level.
Use included nut
driver to adjust
leveling feet in
bottom front two
corners. Nut driver
should insert
through inside of
cabinet down into
feet and adjust as
needed.
HANDLE/LOCKING SYSTEM INSTALLATION
1. Place the locking handle (11)
on the righthand door and
fasten with two #8-32 x 1/4"
slotted hex head bolts and
lockwashers. (See Figure 10)
2. Turn the handle to the
open position. Place
the locking cam (12)
over the square shank
of the door handle.
The latch must be
facing downward as
shown. (See Figure 11).
Place the cotter pin (13)
through the hole of square shank. (See Figure 12)
3. With the handle still in the open position, hook the
locking bars (10) to the locking cam. (See Figure 13)
Once in position, slowly rotate the door handle to
the closed position so the lock bars protrude from
the holes at the top and bottom of the door.
4. Slide the nylon lock bar guide inserts (14) over the
lock bar ends and through the door slots. Push firmly
until the guides snap into place. If necessary, turn
the handle back to the open position and gently
tap with a hammer until the guides slide into place.
(See Figure 14)
CABINET ASSEMBLY CONTINUED
4
Figure 7
10
12
Figure 13
14
14
Figure 14
9
Figure 9
11
Figure 10
13
12
Figure 11
Figure 12
15
8
Figure 8
