PAGE 1 OF 9
0621 IH-7272
H-7272
WET LOCATION EXIT SIGN
1-800-295-5510
uline.com
CONDUIT ENTRY
1. Drill a 3/4" hole through the desired conduit entry
knockout located on the top or side of the frame of
the sign.
2. Route the AC input conduit into frame.
NOTE: All conduit connections must be UL listed
and suitable for wet location parts.
3. To install exit sign, refer to wall, ceiling or end
mounting instructions on pages 2-3.
WARNING! Risk of electric shock. Never
connect to, disconnect from or service while
equipment is energized.
WARNING! Failure to follow these instructions
and warnings may result in death, serious injury or
significant property damage. For your protection,
read and follow these instructions carefully
before installing or maintaining this equipment.
NOTE: These instructions do not attempt to cover
all installation and maintenance situations.
• All service shall be performed by qualified
service personnel. This product must be
installed and maintained in accordance with
the applicable installation codes by a person
familiar with the operation of the product and
the hazards involved.
• This product must be installed in accordance with
applicable installation codes and ordinances.
• Before wiring to power supply, turn off electricity
at fuse or circuit breaker.
• Disconnect AC power and unplug battery
before servicing.
• Consult your local building code for approved
wiring and installation.
• May be used outdoors under cover (-4º to 158ºF)
• Do not let power supply cord touch hot surfaces.
• Do not mount near gas or electric heater.
• Equipment should be mounted in locations and
at heights where it will not readily be subjected
to tampering by unauthorized personnel.
• The use of accessory equipment not
recommended by manufacturer may cause
an unsafe condition.
• Do not use this equipment for other than
intended use.
• The AC voltage rating of this equipment
is specified on the product label. Do not
connect equipment to any other voltage.
SAFETY
TOOLS NEEDED
Phillips Screwdriver
Drill
3/4" Drill Bit
Flathead Screwdriver
INSTALLATION
Figure 1
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
