PAGE 7 OF 36
0319 IH-5836
7. Key in the low limit. Use the
G/N
key
and the
ACC/TTL
key
to move the active digit left and right.
Use the
TARE
key
to increase the numeric value.
8. Press the
ZERO
key
to confirm.
9. Press the
UNIT
key
to exit to the weighing mode.
CHECK WEIGHT OPERATION
1. Place item to be weighed on the scale platform.
Weight will be shown on the display. Scale will beep
if weight is within specified high-low range. Indicators
on right of the display will show if weight is above (HI),
below (LO) or within (OK) the specified range.
CLEAR CHECK WEIGHT
1. Press the
UNIT
key
and the
PCS/SET
key
at
the same time until
SEt H
is shown on the display.
2. To clear the high limit, press the
ZERO
key
.
00000
will be shown on the display with the last
digit blinking.
3. Press
PCS
key
to clear out the value.
4. Press the
ZERO
key
to confirm.
Set H
will be
shown on the display.
5. Press the
TARE
key
until
Set L
is shown on the
display.
6. To clear the low limit, press the
ZERO
key
.
00000
will be shown on the display with the last
digit blinking.
7. Press the
PCS
key
to clear out the value.
8. Press the
ZERO
key
to confirm.
9. Press the
UNIT
key
to exit to the weighing mode.
ACCUMULATION
Use this mode to measure the cumulative weight or
counting values of a sequence of items. The maximum
number of samples is 99 entries or the scale weight
capacity.
MANUAL ACCUMULATION
NOTE: Weight on platform must be equal to
or greater than minimum weight in order for
accumulation mode to operate accurately.
1. Follow steps above to weigh or count items on the
scale platform.
2. Once the stable indicator is shown on the display,
press the
ACC/TTL Print
key
.
ACC 1
will be shown
on the display and the total value will be displayed
for three seconds. Weighing or counting value will
be stored into memory. If a printer is connected, the
data will print.
3. Remove items from platform. Display will return to
zero or a negative value.
4. Add additional items to platform.
5. Once the stable indicator is shown on the display,
press the
ACC/TTL Print
key
. New data will be
added to memory. Continue until all data is added.
RECALL DATA
1. With nothing on the platform, press and release the
ACC/TTL Print
key
to display the total value
of items stored to memory. The number of
accumulated values will be displayed,
ACC
#
,
followed by the total accumulated value for three
seconds.
CLEAR DATA
1. To clear data stored to memory, press and hold the
G/N
key
and the
ACC/TTL Print
key
at the
same time.
2.
ACC 0
will be shown on the display. All the
accumulated values will be cleared from memory.
OPERATION CONTINUED
