PAGE 3 OF 9
1120 IH-3658
NOTE: Table should be in upright position.
1. Secure riser supports to table top using four 1/4-20 x 5/8" bolts and nuts for steel tops or four #14 x 3/4" wood
screws for non-steel tops. (See Figure 1)
NOTE: FOR NON-STEEL TOPS ONLY: Prior to attaching wood screws, drill two pilot holes into the bench through
the holes at the bottom of the riser support using a 3/16" drill bit.
2. Secure riser shelf to supports using two 1/4-20 x 5/8" bolts and nuts on each end.
3. Secure sway braces to riser support and riser shelf using four 1/4-20 x 5/8" bolts and nuts.
4. Risers may be double stacked. Attach a second riser to the first using the same procedures for steel top above.
(See Figures 2a and 2b)
NOTE: Do not stack more than one additional riser onto the original riser.
ASSEMBLY INSTRUCTIONS
Back View
Figure 2a
1-800-295-5510
uline.com
Figure 1
Figure 2b
