PAGE 2 OF 3
0714 IH-3504
ASSEMBlY
ROOF FRAME ASSEMBLY
1. Start top frame assembly as shown. (See Figure 1)
The 36" pipes are used for the roof rafters and 69"
pipes form the length of the frame. Start assembly
with center peak as circled. (See Figure 1)
2. Once you have assembled the roof frame, insert the
legs on one side using the 69" pipes with the foot
pads installed. (See Figure 2)
3. With the top frame on one side and the legs inserted
on the other side (See Figure 3) drape the 1-piece
cover with sides and rear wall over the frame. Make
sure you have the open end in the direction
needed. Pull 1 side down over the frame with the
legs inserted. You can also pull the rear over the
frame partially. Next, insert the legs on the opposite
side and pull the rest of the cover on. (See Figure 3)
COVER ASSEMBLY
1. With frame assembled and cover on, you can now
attach cover to frame using the ball straps. The
grommet holes on the cover are located along the
back and front frame line. (See Figure 4) Attach the
cover by running the strap through the grommet
hole, around the pipe, then loop strap over the
ball. If the straps are too long for a tight fit, you can
double wrap them or make an additional knot in the
strap cord to shorten them.
2. To install side rails and wall support, slide a 69" pipe
into the sleeves at the bottom of the side walls.
(See Figures 5)
3. Use double-side clamp to connect to center leg,
and single-side clamp to connect the corner legs.
(See Figures 6-9)
69" Pipe
36" Pipe
Figure 1
69" Pipe
Foot Pad
Front
Side
Figure 2
Figure 3
Attach
Ball Straps
Figure 4
Figure 5
Figure 8
Figure 6
Figure 7
