PAGE 3 OF 4
1215 IH-2932
1. Use indent to pull battery away from the unit.
(See Figure 1)
2. Make sure it is fully extended out. (See Figure 2)
3. Swing battery cover up. (See Figure 3)
4. Using Allen wrench, remove retaining Allen screw.
(See Figure 4)
5. Pull out battery holder. (See Figure 5)
6. Replace battery. (See Figure 6)
When entering a valid code, you should hear a ‘click’
sound. The green LED will light up, and you can turn the
knob to the unlocked position.
An incorrect code is indicated by three flashes of the
red error light.
Five incorrect entries will result in the lock being
temporarily disabled for 2 minutes; during this time any
entry attempts will be met with three flashes of the red
error light.
TO RE-LOCK:
Turn the knob from the unlocked position to the locked
position, listen for the lock mechanism to operate by
hearing a "click" sound, and confirm the knob is locked.
USING THIS LOCK IN LOCKER MODE:
Follow the procedure below to change operation mode
from Single User/Station mode to Locker mode :
1. Unlock the unit.
2. Remove the battery for 10 seconds.
3. Press the
PROGRAM Key while the battery is removed.
4. Insert battery and continue holding
PROGRAM key.
5. Wait until all 3 LEDs (Red, Green and Yellow) turn on
and fade out at the same.
6. Release the
PROGRAM key.
7. Enter the 6 digit Master code.
8. If code was entered correctly, the yellow LED will be lit.
9. Press button number 2.
10. Once the lock switches to Locker mode, the LEDs
will each flash for one second in the following order:
Green, Yellow and Red.
11. Proceed to operate the lock in Single User/Station mode.
OPERATION
REPLACING THE BATTERY
Indent
Figure 1
Figure 4
Figure 5
3-Volt Lithium CR2032
3-Volt
Figure 6
Figure 2
Figure 3
