PAGE 2 OF 4
1215 IH-2932
TO PROGRAM TO A 6-DIGIT MASTER
CODE
(overwrite the default Factory code):
THE FACTORY CODE IS 531423 AND MUST BE OVERWRITTEN
BY A NEW 6 DIGIT MASTER CODE.
1. With knob in the unlocked position, press the
program button 5 times until the green LED lights up.
2. Enter the default 6 digit Factory code.
a. If the code is correctly entered, the GREEN and
RED LEDs will flash.
b. If the code is incorrectly entered, the RED LED will
flash.
3. Enter the Factory code again. The RED, GREEN and
YELLOW LEDs will light up.
4. Enter the desired 6 digit Master code. The RED,
GREEN and YELLOW LEDs will simultaneously flash.
5. Enter the newly created Master code again.
a. If incorrect, the RED LED will flash.
b. If the code is entered correctly, all 3 LED`s will
flash consecutively for 5 seconds.
Your Master code is now stored. The Factory code is
erased. To program a NEW Master code, follow the
same procedure above, entering the current Master
code instead of the Factory code.
TO PROGRAM A SUPERVISOR CODE:
1. With the knob in either the unlocked or locked
position, press the program button. If you do not
enter either the Master code or control key-fob
within 10 seconds, the red error light will flash and
exit programming.
2. Enter the Master code provided with your lock.
a. If you do not enter a Supervisor code within 10
seconds, the red error light will flash twice and
exit programming.
b. If you enter the Master code incorrectly. the red
error light will flash and exit programming.
c. If you enter the Master code or the control key-fob
correctly, the red light will light up for 10 seconds.
3. Enter a User code (3-6 digits in length).
4. Push the program button again to finish. A successful
code storing is indicated by 6 green light flashes.
TO PROGRAM A USER CODE:
1. With the knob in the unlocked or locked position,
press program button twice. The red LED will light up.
2. Enter the Supervisor code.
a. If you do not enter either the Supervisor code
within 10 seconds, the red error light will flash
and exit programming.
b. If you enter the Supervisor code incorrectly, the
red error light will flash and exit programming.
c. If you enter the Supervisor code correctly, the
yellow LED will light up for 10 seconds.
3. Enter a User code (3-6 digits in length). If you do not
enter a User code within 10 seconds, the red error
light will flash and exit programming.
4. Push the program button again to finish. A successful
code is indicated by 6 green light flashes.
TO ERASE THE USER CODE
1. Press the program button twice. The red LED will
light up.
2. Enter the Supervisor code.
a. The yellow LED will light up for 10 seconds.
b. If the Supervisor code is entered incorrectly,
the red error light will flash twice and exit
programming.
3. Enter 1-1-1-1-1.
4. Press the program button. If the User code is
successfully erased, the green LED will flash 6 times.
PROGRAMMING
