PAGE 3 OF 9
0715 IH-2079
MAINTENANCE
CLEANING
After use, clean residue from top and bottom of heater blade
with Scotch-Brite™ Pad (S-11724). Brush until metal is bright.
• Remove heater cover. To remove blade, pull back on
spring-loaded arm. (See Figure 10) Lift blade assembly
up and forward to release. DO NOT LOOSEN SET SCREWS.
Reverse to reassemble.
Use Air Gun or ULINE Air In A Can to clean parts of plastic
residue. (See Figure 11)
LUBRICATION
Weekly (more often with high usage) – Apply a few drops of
10-20W machine oil to oiling points. (See Figure 11) Make sure
to clean dirt and debris from parts before applying oil.
ADJUSTMENTS
STRAP WIDTH
Make adjustments at the Strap Outlet and the Strap Inlet.
1. Machine comes preset for 1/2" strapping.
2. Strap Inlet: Loosen two black screws with Allen wrench. Set
the Strap Inlet guide about 1/16" wider than the strapping
you are using and align with the Strap Outlet. Retighten
socket screws. (See Figure 7)
3. Strap Outlet: Loosen two Phillips head screws.
(See shaded areas in Figure 8) Adjust the width to accept
width of strap you are using. Set the strap outlet guide at
1/2" for 1/4" and 3/8" strapping and 5/8" for 1/2" strapping.
Retighten screws. (See Figure 8)
TENSION ADJUSTMENT
1. The strap tension adjustment handle is located at the
back of the machine. (See Figure 9)
2. Machine comes preset at 0 tension. Recommend starting
at middle point of tension gauge bar.
3. Turn the handle clockwise to increase tension;
counterclockwise to decrease tension.
9 12
15
9
6
12
15
TIGHT LOOSE
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Strap Inlet
Strap Outlet
Tension
Adjuster
Blade
Assembly
Set
Screws
Clean
Blade
Spring Loaded Arm
Air and
Oiling Points
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.ca
