0615 IH-1607
PAGE 3 OF 6
ASSEMBLY
SET UP INSTRUCTIONS
NOTE: Your floor scale was shipped with the four
threaded leveling feet adjusted for a flat and
even floor. The leveling feet are locked in place
with locknuts.
1. Plug the instrument cable connector into the digital
weight indicator. This cable is located in the junction
box compartment of the floor scale.
2. To access the instrument cable with connector,
remove the screws from the access cover plate, and
then remove the cover plate. (See Figure 2)
3. Route the cable from the inside of this compartment
through the opening in the backside and out from
under the scale to your digital weight indicator.
4. Plug the instrument cable connector into the digital
weight indicator.
5. Plug the 110V power plug from the digital weight
indicator into a 110V wall socket.
6. Press the power button located on the front of the
indicator. The scale will automatically turn on when
plugged in. You are now ready to weigh.
MODEL/SERIAL NUMBER LOCATIONS
The model identification label is located on the side of
the frame next to the junction box access plate. Include
both model number and serial number when making
inquiries or ordering parts.
CALIBRATION
This scale was calibrated at the factory.
DO NOT ATTEMPT
TO CALIBRATE THIS SCALE.
WARNING! Breaking, removing or tampering
with the lead seal that locks-out the calibration
switch on the digital weight indicator will void all
warranties. Calibration is performed by certified
scale service agencies only.
Contact your local weights and measures service
agency for calibration services.
Junction Box Access Cover
S
C
A
L
E
Figure 2
