PAGE 4 OF 8
0713 IH-1393
NOTE: If the temporary bolts are not removed
before the frames are joined side by side, the
frames will have a 1/8" gap between them.
JOINING uNITS TOGETHER
1. If joining a 3-wide unit beside another unit,
temporarily install a bolt and nut into the third and
sixth holes down from the top of the outer frame(s)
that will be joined to the adjacent locker frame(s).
(See Figure 6) The center locker frame can be
bolted complete. If locker is just a stand alone
3-wide unit, finish attaching the frames using 38
bolts and nuts. Check and tighten all permanent
bolts.
SECuRING uNITS
1. Anchor units to wall or floor. units are not intended
to stand free and may topple if not secured. (units
standing back to back should be bolted together.)
CAUTION: Care must be taken to assure
that lockers are set plumb and true before
anchoring.
2. If units are not pre-numbered, optional number
plate and plastic cover (9) may be attached with
two push plugs (10).
3
Figure 4
7
8
ASSEmbLy CONTINUED
Figure 5
Figure 6
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
