U-Line H-11225, Руководство пользователя, Страница: 3 / 18

PAGE 3 OF 18 1223 IH-11225
ASSEMBLY CONTINUED
5. Leveling feet come pre-installed to each foot. If
installing casters, remove the leveling feet by
turning counterclockwise. Install casters in the same
area where leveling feet were located by turning
clockwise. (See Figure 5)
6. Place tabletop on a flat, non-marring surface
with pre-drilled hole side facing up. Place frame
assembly onto tabletop and center front to back
and side to side. Recommended end of support
plate is 2" from edge of table top, but no more
than 4" to ensure handle can operate. (See Figure 6)
NOTE: Pre-drilled holes in table top are not
used for this product.
NOTE: Support beams may need to expand for
the frame to align. To expand, loosen the four
pre-installed Allen head bolts. Adjust length
of support beams. Evenly expand both sides,
ensuring there is metal material under holes
for bolts to attach.
NOTE: Tighten using four M6 x 10 mm socket
cap screws (D) with 4 x 4 mm Allen Wrench and
re-tighten pre-installed Allen head bolts.
(See Figures 7-9)
7. Using 16 self-tapping screws (F) and drill with Phillips
head drill bit, fasten frame assembly to tabletop.
(See Figure 10)
NOTE: Use shaded circles as guide for
attachment points. Holes are not predrilled.
Figure 5
Figure 7 Figure 8
Figure 9
Unscrew Adjust
Tighten
Figure 6
2-4" From
Edge
Figure 10