PAGE 3 OF 18
0623 IH-4602
ASSEMBLY
SETUP INSTRUCTIONS
NOTE: Floor scale is shipped without the four
threaded leveling feet installed to protect
against damage. See page 1 for feet
installation and level adjustments.
1. Remove the screws from the junction box access
cover plate and remove cover plate. (See Figure 2)
2. Find the instrument cable inside this compartment.
Route the cable from inside through the opening in
the backside of tray and out from under scale into
digital weight indicator.
3. Plug instrument cable connector into the digital
weight indicator. (See Figure 3)
4. Plug 110V power plug from the digital weight
indicator into a 110V wall socket. (See Figure 3)
5. Press the power button located on the front of the
indicator. The scale will automatically turn on when
plugged in. The scale is ready to weigh.
MODEL/SERIAL NUMBER LOCATIONS
The model identification label is located on the side of
the frame, next to the junction box access plate. Include
both model number and serial number when making
inquiries or ordering parts.
CALIBRATION
This scale was calibrated at the factory.
DO NOT ATTEMPT
TO CALIBRATE THIS SCALE.
WARNING! Breaking, removing or tampering
with the lead seal that locks out the calibration
switch on the digital weight indicator will void all
warranties. Calibration is performed by certified
scale service agencies only.
Contact your local weights and measures service
agency for calibration services.
Figure 2
Junction Box Access Cover Plate
Top of Scale
ON/OFF
Tare
Zero
Total
Count
lb/kg
Gross
Figure 3
110V power plug
Instrument Cable
Connector
Digital Weight
Indicator