PAGE 9 OF 42
0323 IH-10268
TABLETOP POWER STRIP ASSEMBLY
1. Choose desired location for power strip. Place two
supplied mounting clips roughly 32" apart (clip side
up). Using an electric drill, fasten to tabletop with
two supplied wood screws. (See Figure 30)
2. Secure power strip by snapping into the mounting
clips. (See Figure 31)
MONITOR ARM ASSEMBLY
1. Align monitor arm mounting bracket with uprights
at desired height.
2. Secure to uprights with two M6 x 35 mm or M6 x 50 mm
Allen head bolts, two small flat washers and two hex
nuts using an Allen wrench and 10 mm wrench.
(See Figure 32)
ATTACHING MONITOR
NOTE: Ensure monitor has a VESA hole pattern of
100 x 100 mm or 75 x 75 mm. (See Figure 33)
NOTE: If monitor is attached to a fixed base,
remove monitor from base.
CAUTION! Be careful not to scratch screen
during installation.
1. Easy-adjust monitor mount includes a built-in
counterweight system for free-range motion. Arm in
mount may need to be adjusted to allow monitor to
stop at desired position. Attach monitor to plate.
(See Figure 34)
2. To adjust the counterweight, use 5 x 5 Allen wrench
on screw above middle joint. Turn toward "–" if
monitor raises up. Turn toward "+" if monitor lowers.
Adjust until mount can be stopped at desired
position. (See Figure 35)
OPTIONAL ACCESSORIES CONTINUED
Figure 34
Allen
Wrench
Large Flat
Washer
Use appropriate bolts for monitor.
Figure 35
Adjust swivel
with Allen
Wrench
±180º -85º ~15º
±180º
±90º
Adjust Tilt with
Allen Wrench
Figure 33
75 x 75 mm or
100 x 100 mm
75 x 7
5 m
m o
r
10
0 x 1
00 m
m
Figure 31
Figure 30
Mounting Clip
Small Flat
Washer
Hex Nut
Allen Head
Bolt
Figure 32
