PAGE 5 OF 42
0323 IH-10268
14. Place stringer cover over holes on stringer. Tighten
Allen head bolts on bottom of stringer to secure.
(See Figures 14a-14b)
15. Connect ethernet style cords to M1-M4 ports on
control box and lifting columns. (See Figures 15-16)
16. Connect handset to part labeled "HS" and power
cord to power port labeled "AC" on control box.
(See Figure 16)
NOTE: Cable ties may be used on underside
of tabletop to hide cords.
UPRIGHT ASSEMBLY
1. Carefully set table upright and recheck all nuts,
bolts and screws for tightness.
2. Position upright on back corner of tabletop. The
mounting plate should be positioned directly over
the previously drilled holes. Fasten four 2⁄" bolts
and washers through uprights, tabletop and support
plates using 10 mm wrench. Secure with flange nuts
on underside of table. (See Figure 17)
3. Repeat steps 1-2 for remaining upright. (See Figure 17)
ASSEMBLY CONTINUED
Figure 17
Flange Nut
Mounting
Plate
Upright
Leg
Washer
2⁄" Bolt
Figure 15
Control Box
Figure 16
Ports for Lifting Columns
Power Port
Handset Port
Lifting Column
Figure 14a
Figure 14b
