0812 IH-1024
PAGE 5 OF 7
TROUBLE SHOOTiNg
PROBLEM
CAUSE
REMEdy
Excessive jams
Teeth screws are loose or
staples are wrong size.
Tighten screws and check staples.
Uneven clinch
Wrong staple size.
Check for proper leg length adjustment and
clincher size.
Unclinched staple
Teeth are loose or broken.
Check and replace teeth as needed.
Stop using the stapler immediately if any of the following problems occur.
Serious personal injury could occur. Any repairs or replacements must be
done by a qualified person or authorized service center only.
WARNiNg
TEETH rEPLACEmEnT
1. Loosen screws and nut with an 8 mm wrench and
4 mm Allen wrench. (see Figure 10)
2. remove the magazine assembly. (see Figure 11)
Figure 10
Figure 11
Figure 12
3. Loosen screws with 3 mm Allen wrench.
(see Figure 12)
4. Change teeth one at a time to prevent reverse teeth.
