0812 IH-1024
PAGE 2 OF 7
SAfETy iNSTRUCTiONS
sAFETY insTrUCTiOns
1. read the manual and understand all safety
instructions before operating the stapler. if you have
questions, contact Uline at 1-800-295-5510.
2. Always wear protective equipment; e.g., safety
glasses, hearing protection and head protection.
3. do not place your hand or any other body part in
the staple clinching area.
4. never point the stapler at yourself or anyone else.
LOAdinG THE sTAPLEr
1. Pull the pusher back until it stops on pusher pivots.
rotate pusher to position. (see Figure 1)
2. insert up to 2 sticks of appropriate staples into the
magazine. Let the sticks slide forward to the front of
the magazine. (see Figure 2)
3. Pull the pusher back to an upright position and
gently let the pusher slide forward against the
staples. do not let the pusher slide forward and
strike the staples at high speed as this may deform
the staples and damage the stapler.
AdjUsTinG sTAPLE LEG LEnGTH
1. Loosen the set screw with a 3mm Allen wrench on
the bottom. (see Figure 3)
2. Turn adjusting rod 180º with a screw driver to the
desired setting.
3. if you are using ¾" staples set L up.
4. if you are using
5
⁄
8
" staples set s up. (see Figure 4)
5. Tighten the set screw.
Figure 1
Figure 2
Figure 3
Figure 4
