PAGE 3 OF 15
0922 IH-8966
1. Flip the table back over onto a smooth, non-marring
surface. Remove adjustable feet from tube legs
using a flat head screwdriver. (See Figure 6)
NOTE: You may need to use a rubber mallet or
hammer to assist.
2. Hold caster base and rotate nylon bushing
clockwise. This will cause the rubber piece to
expand. (See Figure 7)
3. Expand the rubber enough so that it will fit snugly
into the tube leg.
4. With caster fully inserted into the leg, turn clockwise
until caster is secured to tube leg. (See Figure 8)
NOTE: If too loose, pull out caster and tighten
further. Repeat step 2.
Figure 8
Figure 7
CASTER ASSEMBLY (OPTIONAL)
Figure 6
Nylon Bushing
Rubber Expansion Piece
Caster Base
Tube Leg
