0314 IH-2930
PAGE 3 OF 3
TO LOAD THE ECONODOT CONTINUED
7. Press down on the spring-loaded lever located
to the right of the motor-driven and clamp rollers
in order to create space between the two rollers.
Thread the liner between the two rollers. Release the
spring loaded lever so the motor-driven and clamp
rollers sandwich the liner. Close the door on the
shroud. (Shroud door must be closed to operate the
machine.)
8. Pull on the liner until a single adhesive pattern
comes to rest on the nose plate.
9. Spent liner should trail into a trash receptacle.
All maintenance and repairs should be performed
by a technical staff member such as a technician,
electrician, maintenance personnel or equivalent.
Maintenance performed by unqualified persons
nullifies the EconoDot warranty.
It is important to keep the sensors free from debris.
Malfunctions not addressed in the troubleshooting
section of these instructions can be directed to the
Repairs Department at ULINE.
The following chart outlines problems that could arise
while using the EconoDot. Malfunctions experienced
outside of the issues outlined below will need to be
addressed by an experienced, professional technician
or electrician.
MAINTENANCE/REPAIRS
TROUBLESHOOTING
OPERATING ISSUE
CAUSES
RECOMMENDATIONS
Motor doesn’t turn
Too much tension on Adjust tension on
the Supply Reel Spindle;
Adhesive patterns built up on Peeler
Rollers.
Adjust tension accordingly
Peel adhesive patterns off the Peeler
Rollers
Liner advances more than
one adhesive pattern at a
time
Dirty registration sensor
Clean
When the liner advances,
the adhesive pattern is not
centered on the nose plate
Improper registration
Loosen the screws behind the sensor
and adjust accordingly.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
OPERATION AND LOADING INSTRUCTIONS CONTINUED
Nose Plate
U-Channel
Sensor
Supply Reel
Clamp Knob
Peeler Roller
Separation
Lever
Shroud with
Hinged Door
Spring-loaded
Lever
Supply
Reel
Plate
Figure 2
