U-Line Combo CO29, Инструкция по использованию и уходу

Страница: 13 / 24

CO29, CO75 13
IMPORTANT IMPORTANT
Use only genuine U-Line replacement parts. U-Line
ice maker parts are not the same as standard FSP
Whirlpool parts. Using non U-Line parts can reduce
ice rate, cause water to overflow from ice maker
mold, damage the unit, and may void the warranty.
Leveling
It is important that units equipped with adjustable feet
are level, for proper door and ice maker (if equipped)
operation.
NOTE: Model CO29 DOES NOT have leveling feet. This
model MUST be placed on a level surface to operate
properly.
To level units with adjustable feet:
Figure 17
1. Use a level to check the levelness of the unit from
front to back and from side to side. Level should be
placed along top edge and side edge as shown
(Figure 17, 1) .
Figure 18
2. If the unit is not level, adjust the feet on the corners of
the unit as necessary (Figure 18) .
3. Check the levelness after each adjustment and repeat
the previous steps until the unit is level.
Door Alignment Check and Adjustment
IMPORTANT IMPORTANT
Properly aligned, the door’s gasket should be firmly
in contact with the cabinet all the way around the
door (no gaps). Carefully examine the door’s gasket
to assure that it is firmly in contact with the
cabinet. Also make sure the door gasket is not
pinched on the hinge side of the door.
Figure 19
NOTE: Model CO75 shown (Figure 19)
1. Loosen (do not remove) top (Figure 19) and bottom
hinge screws.
2. Align door squarely with cabinet.
3. Make sure gasket is firmly in contact with cabinet all
the way around the door (no gaps).
4. Tighten bottom hinge screws.
5. Tighten top hinge screws.
ULIN_0225_A
1
1
ULIN_0042_A
ULIN_0210_A
ULIN_016357_30089.fm Page 13 Monday, March 27, 2006 10:25 AM