QUICK START GUIDE
u-line.com
10
USER GUIDE
u-line.com
General Installation
Install Tower on Countertop
(see template at the end of this section)
1. Use template to drill four mounting holes.
2.
Drill 2-3/4" diameter hole through countertop.
3.
Remove four Phillips screws (secured with nuts on the inside of the refrigerator) and lift off cap to reveal tower mounting
hole.
4. Slide keg refrigerator into place.
5. Position gasket over mounting hole.
6.
Insert tubing into 2-3/4" hole.
7. Secure tower to countertop using four Phillips screws and nuts.
Note: Screws included with the kit will accommodate many different countertops. For a customized fit, it may be
necessary to acquire screws that are size to the thickness of your countertop.
8. Continue with CO
2 and beverage connections.
NOTE: For proper operation of your refrigerator, IT IS NECESSARY
to install air-tight insulation between the refrigerator and
the tower. The insulation will need to run from the interior of the refrigerator up into the interior of the tower.
Front Face
of Unit
2
¾
”
(70 mm)
Hole Diameter
Power Cord
2”
(51 mm)
15”
(381 mm)
Rear Wall
24 ¼”
(616 mm)
12 ½”
(318 mm)
11 1⁄8”
(283 mm)
1 11⁄16”
(43 mm)
7 ½”
(19 1 mm)
Rear Wall
Countertop
11-1/8”
(283 mm)
Front edge of drilled hole
to front face of unit
Beverage
Tube
Insulation
Diagram A
Diagram B
Insulation
