www.U-LineService.com
4
06/2006
2175DWRWC — Drawer Model Wine Captain
®
Exterior Cleaning
(As Required)
Black Models:
• Clean glass drawer fronts with glass cleaner. The
drawers, grille and cabinet may be cleaned with a mild
detergent and warm water solution. Do not use
solvent-based or abrasive cleaners. Use a soft sponge
and rinse with clean water. Wipe with a soft, clean
towel to prevent water spotting.
Stainless Steel Models:
• Stainless steel models can discolor when exposed to
chlorine gas, pool chemicals, salt water or cleaners with
bleach.
• Clean glass drawer fronts with a non-chlorine glass
cleaner. Keep your stainless steel surfaces looking new
by cleaning with a good quality all-in-one stainless
steel cleaner/polish on a monthly basis. For best results
use Claire Stainless Steel Polish and Cleaner, which can
be purchased from U-Line Corporation. (The part
number is 173348.) Comparable products are
acceptable. Frequent cleaning will remove surface
contamination that could lead to rust. Some
installations may require cleaning on a weekly basis.
• Do not clean with steel wool pads.
• Do not use stainless steel cleaners/polishes on
the glass surfaces.
• Do not use cleaners that are not specifically
intended for stainless steel on stainless steel
surfaces (this includes glass, tile and counter
cleaners).
• If any surface discolors or rusting appears, clean it
quickly with Bon-Ami or Barkeepers Friend Cleanser
and a non-abrasive cloth. Always clean in the direction
of the grain. Always finish this process with Claire
Stainless Steel Polish and Cleaner or comparable
product to prevent further problems.
• Use of abrasive pads such as Scotchbrite will
cause the graining in the stainless to become
blurred.
• Rust that is allowed to linger can penetrate into the
surface of the stainless steel and complete removal of
the rust may not be possible.
Your U-Line product has been designed for built-in
installation. Your unit does not require additional air
space for top, sides or rear. However, the front grille must
NOT be obstructed and clearance is required for electrical
connection in the rear.
Note:
Unit can NOT be installed behind a closed cabinet
door.
Cut-Out Dimensions
Follow the cut-out drawing in
Figure 1
. The 24-3/16"
width allows 1/4" for ease in installation and removal of
the unit. 24" is the counter depth in most installations.
The unit is 23-11/16" deep including the drawer and not
the full handle (see
Figure 2
).
3 Prepare Site
Figure 1
See Electrical
Specifications
for Power Supply
34-1/4"
to
35-1/8"
24-3/16"
23-11/16"
