www.U-LineService.com
2
04/2006
Overlay Panel Kit Parts Supplied
Prepare the New Overlay Panel
Refer to the Overlay Panel Preparation instruction sheet,
part number 30139.
IMPORTANT
The overlay door panel must not weigh more than
20 lbs. The thickness of the door panel must be 3/4".
Remove Gasket from Door
1. Remove door from shipping box.
2. Turn door over so gasket is facing up. Pull door gasket
out of the groove completely. Start in the middle and
pull outward, moving toward the edge
(Figure 2)
. This
may take some force, but be careful.
3. Place gasket on a flat, clean surface.
Checking Overlay Fit
CAUTION
If panel does not seat properly, determine the cause
of the problem by reviewing the Preparation
Instructions P/N 30139.
1. Lay overlay panel on front side of door. Make sure
panel is fully seated on all four sides.
2. Visually check for gap between panel and glass. If there
is an objectionable gap, continue to
Applying Foam
Tape to Overlay
.
3. If there is little or no gap between panel and glass,
continue to
Attaching the Overlay Panel
.
Item
Part
Number
Description
Quantity
1
12029-BLK
Top Pivot Plate - Black
1
2
12041
Insert 8mm Plug
2
3
20002
Screw #6 x 1.0 Pan HD
10
4
30138
Mounting Instructions,
21XX (not shown)
1
5
30139
WC Overlay Prep Sheet,
21XX (not shown)
1
6
31672
Door Closer - Male
1
7
31673
Door Closer - Female
1
8
35003
Foam Tape .093 x .375 x
8’ (not shown)
1
9
35003
Zipper Bag (holding
closer ASM) (not shown)
1
10
42096
Pivot Post
2
11
42122
Screw #6 x .50 Lg Flat HD
2
ULIN_0412_A
Figure 1
DOOR
GASKET
ULIN_0414_A
Figure 2
NOT FULLY SEATED
LITTLE OR NO GAP
OBJECTIONABLE GAP
ULIN_0415_A
Figure 3
